Kazoo
Copyright Claim
Kazoo
Boost
6
13
11
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
6
13
11
2
21
35
Released
Description
Just a simple kazoo. You have to add a piece of plastic wrap into the hole, put the washer on top and screw the lock into it. If some of the plastic wrap is looking out of it, you can just rip it off
Comment & Rating (11)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice print!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it doesn’t work and even if you need some extra tools to set it up the description doesn’t say.
The designer has replied
0
Reply
Did you use a small piece of plastic wrap/foil?
0
Reply
I would know where to put it
0
Reply
not know
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
amazing, I used a small bit of baking paper in the middle to make it vibrate but it’s perfect, works very well, great quality
The designer has replied
0
Reply
oh yeah, right, forgot to add to the description. You actually have to do it. You can put a small piece of plastic wrap into the hole and screw the other piece into it. Now you can just rip the rest off, the needed part is safe inside
0
Reply
Boosted
Very good model it works perfecty
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld