Overview

While I've been setting up my printer space to be a bit more space-efficient, I fell in love with Jerrari's Ikea Lack Enclosure Drawers.

While I really liked the horizontal designed steel sheet holders for the Lack that I've found, my specific want was to have something that could go alongside a few of Jerrari's ingenious drawer system.

This Vertical Steel Sheet Holder is a 2-piece print that clips together, and can then be screwed into the Ikea Lack tabletop with the same #4 x 3/4 inch screws that the aforementioned drawers called for.

Printing

Files: Print the normal bottom half (LackVertSteelSheetHolder_BottomHalf) to mount sheets under the right side of the tabe, or the mirrored version in order to mount under the left. The top half works for either orientation.

Materials:

-recommend printing these pieces in PETG-- PLA should hold up fine, but the extra flex of PETG may prove better to work with

-5x (#4 x 3/4 inch screws)

Brim: recommended due to the length of the piece to reduce warping, but not absolutely necessary

Infill: 20+% recommended for stability

Assembly

Step 1) Print both pieces separately

Step 2) Snap both pieces together in orientation shown in pictures above

Step 3) Mark and drill pilot holes for the holder

Step 4) Attach to table using 5x (#4 x 3/4 inch screws)

Open and welcoming any and all feedback!