Simple Octowatch
Copyright Claim
Simple Octowatch
Boost
6
4
4
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
2.1 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
6
4
4
1
11
8
Released
Description
A simple watch from the series “octonauts”.
It is multi color printable. The surface looks not good in this example, maybe you should enable ironing (I enabled it now in the print profile).
The Bracelet is not included, I tried one with TPU, but not with a good success yet. I wil upload maybe one in future.
Comment & Rating (4)
All
I tried it and end up having the same result as show on your pictures. Ironing was on « all top surface »
The designer has replied
0
Reply
lete try this evening if I can find the cause
0
Reply
I did some test prints, playing around with ironing and the prime tower in all combinations:
from left to right:
- ironing on + prime tower on
- ironing on + prime tower off
- ironing off + prime tower off
- ironing off + prime tower on
sadly I dont get the bad results again. Things that have changed since my last print are the bambulab version and my (new) filaments are way better stored and pretty dry.
Anyway I will update the file to version 1.1 turning ironing off and the prime tower on. hope that helps.
0
Reply
Boosted
GG !
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld