Back Plates for MedalDisplay 4D - The Modular 3D Printed Display Case
Included are some Variable Mounting Pins, these square mounting pins are designed to allow for alignment when mounting to the wall.
Each side is a different distance from the centre, if your frame is crooked, try turning the mount 90 degrees and trying again, each side is in increments of 1mm to hopefully help with keeping things straight and neat
There is a small clip piece that is used in the middle to keep the alignment together, it is designed to fit in quite tightly. Removing this clip after fitting is fairly easy, but may damage the clip and need to be reprinted, it's only a few minutes of printing though.
If the holes don't align, you're attaching the backplate on backwards, just flip it over.
As Always, Glue is not required but definitely recommended once you are happy with your frame.
MedalDisplay is 100% Free. However if you'd like to support me, feel free to buy me a coffee