Inspired by the “THIS IS FINE” meme, I have created this cross-over with Fallout Boy. I like the result and hope you will enjoy it as well. This print uses 6 unique filaments, print instructions below.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

The Model is 157.5x153.3mm in size
You may print at higher layer heights below the Min Depth of 0.24mm
The Max Depth is 2mm and the Actual Depth is 2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Matte Scarlet Red Transmission Distance: 2
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #2 (0.32mm) swap to Blue
At layer #4 (0.48mm) swap to Orange
At layer #6 (0.64mm) swap to Scarlet Red
At layer #7 (0.72mm) swap to Yellow
At layer #10 (0.96mm) swap to Jade White for the rest.