5.15更新:优化模型沟槽深度,增加4环模型
4.28更新:增加五环模具,更适合轴承管,优化切片接缝设置
使用ASA或ABS打印:烤箱/空气炸锅70度5分钟,取出后凉水冲20秒(或者风扇吹1分钟)
Use ASA or ABS printing: oven/air fryer at 70 degrees for 5 minutes, take out and rinse with cold water for 20 seconds (or blow with a fan for 1 minute)