I needed a replacement hose clamp, and I wanted it offset from the wall a little bit. As a result, the Clamp and Offset were born.

This can be used to clamp a garden sized hose to a wall or fence.

Although the clamp can be used on its own, included with the clamp is an offset piece. This piece is optional. It is designed to keep the hose away from the wall or fence. The offset piece can be used flat side down to keep the hose approximately 15mm from the wall or lengthwise to keep the hose approximately 25mm from the wall.

The offset is also useful to keep the hose away from the wall if it is near a tap. If the hose is near a tap and flush against the wall, it may be difficult to use the tap.

The screw holes in the clamp and offset are oval to give a little bit of play should you already have screw holes in your wall or fence. Hopefully, this will help eliminate the need to drill new holes.

Standard default printing profiles are sufficient for printing. 15% infill is good. No supports needed. However, using something other than PLA is recommended since it will be exposed to UV light and high/low temperatures. I recommend PETG.

One set of the clamp and offset will use approximately 15 grams of filament using a generic standard printing profile with 15% infill.