Hair Bow Tie
Copyright Claim
Hair Bow Tie
Boost
26
44
13
Print Profile(1)
Fine layers, 0.08mm layer, 2 walls, 15% infill
36 min
1 plate
Open in Bambu Studio
Boost
26
44
13
2
103
72
Released
Description
A cute little tie for your hair! Just loop a hair-tie through the back, slip it through itself for a knot, and it's ready to wear!
Because of the slopes, I recommend printing with as low of layer heights as possible. I printed this with .08mm layers (.2mm initial layer). Even so, the print took less than 50 minutes.
Happy printing!
Follow me on Instagram @tjzdesign
Comment & Rating (13)
All
Print Profile
Fine layers, 0.08mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Fine layers, 0.08mm layer, 2 walls, 15% infill
Really cute and easy design.
1
Reply
Print Profile
Fine layers, 0.08mm layer, 2 walls, 15% infill
witziges gimmick
1
Reply
Print Profile
Fine layers, 0.08mm layer, 2 walls, 15% infill
Pěkné, upravil jsem tak, aby se dala navléci gumička a nosit jako motýlek pod krkem. Vytiskl jsem ve dvou velikostech pro sebe větší a originál pro 4letého syna. Půjdeme na svatbu, tak se bude hodit :-)
1
Reply
Print Profile
Fine layers, 0.08mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Fine layers, 0.08mm layer, 2 walls, 15% infill
1
Reply
Boosted
Print Profile
Fine layers, 0.08mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Fine layers, 0.08mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Fine layers, 0.08mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Fine layers, 0.08mm layer, 2 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld