The Rocky Horror Picture Show Poster Fridge magnet
Boost
33
25
8
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
3 h
1 plate
Boost
33
25
8
4
23
23
Released
Description
The Rocky Horror Picture Show movie/theatre poster fridge magnet.
Measuring 65mm wide by 95mm high by 5mm deep
4 colour AMS print, using black, white and red.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (8)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Nice (and, printed fine on textured plate).
The designer has replied
1
Reply
I'm glad you resolved the bed adhesion problem! Thanks again for the ratings, much appreciated
(Edited)1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thank you for the ratings, I appreciate it
0
Reply
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thanks for the rating, I appreciate it
0
Reply
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld