Cable Guide A1 and A1 Mini
Copyright Claim
Cable Guide A1 and A1 Mini
Boost
31
73
21
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
19 min
1 plate
0.2mm layer, 3 walls, 15% infill
Designer
20 min
1 plate
Boost
31
73
21
3
82
102
Released
Description
I designed this guide because I was afraid the cable might get tangled,Keeps cable out of harm's way, I wish you fun with it and would like feedback, use at your own risk, I have it on my printers for months without any problems, it just does its job.
Comment & Rating (21)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
It does a good job of holding the cable out of the way, however, I feel it's a little too close and causes too hard of a bend in the cable.
Could be improved by raising it and moving it a few mm forward.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The part printed great. Used Overture Black PETG. Good amount of snug on the cable to keep it in place
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
very useful for preventing any tangling 👍
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
nice model with helpful function 👌
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Works great. The fit is snug, but it's a plus. It makes it secure and I no longer have to worry about the cable flirting with the z tower.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
fits good
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Follows the function, cabel fits good inside
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
grande ottimo
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
a little bit tight
The designer has replied
0
Reply
Check your Printer Calibration :-) (Flow.....)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld