I scaled up @JorgedP.O.'s model so I could fit the 13.66mm dice I have. Standard 16mm dice also are accomodated by this size up. Rather than 7mm height, everything scaled to match 10mm height. My bed was not large enough to print this, so I modified the files to remove the two “inner” hinge pieces and created a new “snap in” hinge. I did not have any issues with PLA being too brittle to "snap".

Print the plate twice, as both sides are identical. Remove “center link open” and “center link open 2” on the second print or you will have two extras.