Cute Pig

Copyright Claim

Cute Pig

Boost
268
377
66

Print Profile(5)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

Single color, 0.12mm layer, 2 walls, 10% infill
Single color, 0.12mm layer, 2 walls, 10% infill
Designer
44 min
1 plate
4.8(19)

3 colors, 0.12mm layer, 2 walls, 10% infill
3 colors, 0.12mm layer, 2 walls, 10% infill
Designer
5.2 h
1 plate
4.8(5)

A1 mini, Single Color, 0.12mm layer, 2 walls, 10% infill
A1 mini, Single Color, 0.12mm layer, 2 walls, 10% infill
53 min
1 plate
4.7(7)

Fine Profile, 0.12mm layer, 2 walls, 10% gyroid infill
Fine Profile, 0.12mm layer, 2 walls, 10% gyroid infill
35 min
1 plate
5.0(1)
Click to see more

Open in Bambu Studio
Boost
268
377
66
19
521
293
Released

Description

Cute piggy

Comment & Rating (66)

Please fill in your opinion
(0/5000)

Print Profile
3 colors, 0.12mm layer, 2 walls, 10% infill
The designer has replied
0
Reply
Thank you for the great rating. Nice color combination.
0
Reply
Print Profile
Single color, 0.12mm layer, 2 walls, 10% infill
The designer has replied
0
Reply
Nice garden :D
0
Reply
Cute!
The designer has replied
1
Reply
Glad that you like it.
0
Reply
Print Profile
A1 mini, Single Color, 0.12mm layer, 2 walls, 10% infill
easy to print.
1
Reply
Thank you for the great rating.
0
Reply
Print Profile
A1 mini, Single Color, 0.12mm layer, 2 walls, 10% infill
cute tanks nice desing
1
Reply
Thank you for the great rating. Glad that you like it.
0
Reply
Print Profile
Single color, 0.12mm layer, 2 walls, 10% infill
Prints very well
The designer has replied
1
Reply
Thank you for the great rating.
0
Reply
Print Profile
3 colors, 0.12mm layer, 2 walls, 10% infill
Way cute. Granddaughters loved it.
The designer has replied
0
Reply
Thank you for the great rating. Glad your granddaughters loved it :D. Try different color combination.
0
Reply
Print Profile
Single color, 0.12mm layer, 2 walls, 10% infill
The auto-generated supports for the tail were too hard to remove without breaking the tail. Not sure about the solution since I’m new to 3D printing but otherwise it’s a great model and print.
The designer has replied
0
Reply
Thanks for the rating. Usually I put the tail on the table and tear out the support from the other side.
0
Reply
very good!
The designer has replied
0
Reply
Thank you for the comment
0
Reply
Print Profile
Single color, 0.12mm layer, 2 walls, 10% infill
everything was fine
The designer has replied
0
Reply
Thank you for the great rating.
0
Reply