Drill jig I created for a Humancentric Small form factor PC mount.
This mount goes under the desk and I needed a way to mount 20 of these and did not feel like holding the mount up while trying to pre-drill the holes in the desks each time.
Holes are made for a 2mm or 5/64" drill bit and are centered for holes in the mount itself allowing for repeated use of same layout.
This jig works for Humancentric model # 101-2082-V1 in the vertical position as shown in pictures.
Printed with 3 walls and 15% infill. More infill and walls would allow more support of the inner holes, but for the small amount of torque that will be applied this worked just fine for my use.
(This is my first model I've created, any suggestions are appreciated!)