Car cabin decor - Giant dice

About

80mm cube dice that can be hung in a car cabin.

Printing

• No AMS required, just print the parts in different colors.
• Please ensure your printer bed and selected filament have good adhesion.
• There are two choices for the “1” side of the dice, a single dot pip or a heart shaped pip.
• The print profile I've uploaded has brim enabled for the dice body. If you are downloading the raw files, please refer to the print profile I've uploaded for brim settings.
• Depending on your climate, use materials that are suited for car cabins.

Safety

• Ensure safety first if hanging the dice within the car cabin:
  • The dice should not create distractions for the driver or obstruct the driver's view.
  • The dice should not adversely impact other objects around it as the vehicle moves.
  • The string used should be shorten to not allow a small hand to pass through.
  • The materials used to print the dice should be suited for a car cabin under different weather conditions.

Assembly

• After printing, remove the brim from the dice body. Using a deburring tool or file if necessary to get a nice finish.
• Do the following before inserting the pips!
  • Thread one end of a suitable string through the corner hole. Pull out the string end using the larger opening on the “1” face. A pair of tweezers will be helpful.
  • Tied a few dead knots to form a stopper.
  • Retract the knotted end into the dice.
• Install the pips.

Please check out my other models too, TYVM!

___