Easy to print wall mount 墙贴挂钩
Boost
2
2
0
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
Open in Bambu Studio
Boost
2
2
0
0
17
0
Released
Description
EN
this is my first design made in Onshape!
- you'll need command strips to stick this to your wall
- print it on the side, so no supports are needed
- 30% infill (or more) is recommended
CN
这是我第一个用Onshape做的模型
- 粘到墙上要用泡沫胶
- 横着，放倒在侧面打，就不用支撑了
- 推荐至少30%填充
Comment & Rating (0)
All
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld