Book Stack Ornament / Keychain
Copyright Claim
Book Stack Ornament / Keychain
Boost
25
34
10
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
3.1 h
1 plate
0.2mm layer, 2 walls, 15% infill, with hole for keychain
Designer
3 h
1 plate
Boost
25
34
10
0
27
15
Released
Description
This cute little stack of books is a great way to say thank you to all of the wonderful educators in your life.
You can add a ribbon as shown, or a hook to make a cute little ornament, or we can add a keyring for you to use as a keychain. I added a little eye hook in the top of the apple to attach the ribbon. You can also attach a keychain or lobster clasp.
Comment & Rating (10)
All
I tried printing this but apple is not attached and it just turns into blob
The designer has replied
0
Reply
Weird. I've printed this a hundred times, it has sold great. Never had any issues with it with either profile. Did you change any settings when you printed it? Was you filament dry?
0
Reply
Replying to @painters98
No I just imported directly. Not sure what happened
0
Reply
Replying to @decembar2912
I’m so sorry that happened. May be an issue with your filament.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice print
The designer has replied
1
Reply
Thank you!
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, with hole for keychain
Looked good, but didn’t print well for some reason. only scaled up 20% but was a last minute print.
The designer has replied
0
Reply
Can you elaborate on what went wrong? I’ve printed it many times with zero issues. Do you have a photo? besides the scale, what else did you change? was your filament dry?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thank you!
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld