Paint bottle holder 25mm holes
Copyright Claim
Paint bottle holder 25mm holes
Boost
3
10
3
Print Profile(1)
0.2mm layer, 2 walls, 8% infill
Designer
5.2 h
1 plate
Boost
3
10
3
2
13
4
Released
Description
needed a small but strong way to organize my paint bottles.
couldn't find one that fit my needs with minimal material usage, so I made this simple yet clean organizer.
fits bottles, 24.5mm in diameter. perfect for Vallejo paints!
holds 40 bottles total
Comment & Rating (3)
All
I had to print at 101% as some bottles where just too tight otherwise. Not sure if it was the filament eSUN PLA+ or just slight variations in bottle sizes or even label thickness. Fits my needs a lot better than the drawers in the background.
The designer has replied
1
Reply
it may have been the filament as stated, or maybe the material shrunk a bit? lol all my bottles fit snug, but not tight. thanks for printing, and the review!
also same here I had them all in drawers which is a pain to get to sometimes 😅
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld