Door Hook V2
Copyright Claim
Door Hook V2
Boost
6
3
2
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
23 min
1 plate
Boost
6
3
2
0
13
10
Released
Description
Designed this for my bathroom door to hang towels, hangers and bathrobes. Have not tested the strenght but its pretty strong. Printed in ABS but should work for PLA and PETG, just change material in the slicer. My door is 39mm thick so this is what its made for, should work for some bigger or smaller doors aswell. Its also a 3,5mm hole on the top to screw it down to the door so it doesnt slide or fall off.
If you have any suggestion to improve the design or print, please let me know.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 3 walls, 25% infill
Print is good. Failed due to me not cleanign my plate. Can tell item is strong and would do the job.
The designer has replied
0
Reply
Thanks! Better luck with the next print :)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld