Search models, users, collections, and posts
Door Hook V2
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
13
28
8
2
67
49
Released
Description
Designed this for my bathroom door to hang towels, hangers and bathrobes. Have not tested the strenght but its pretty strong. Printed in ABS but should work for PLA and PETG, just change material in the slicer. My door is 39mm thick so this is what its made for, should work for some bigger or smaller doors aswell. Its also a 3,5mm hole on the top to screw it down to the door so it doesnt slide or fall off.
If you have any suggestion to improve the design or print, please let me know.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (8)