Printed out perfectly! Originally printed in PLA but warped after a couple of days in the British spring sun so I can't imagine it would last very long in the actual summer.
Reprinted in PETG and I haven't had anymore warping issues so far.
Strength Issue:Tried printing this multiple different ways and it snapped every time. I used Bambu Basic PETG and tried slowing down the print and still no luck. Walls were very thin and it snapped multiple times in this same spot. Great design otherwise!
It printed good but the clip falls off from the visor if I want the visor to be down. I need the clip to be tighter, probably half to 1/3 less radius on it. Is there a way to adjust this? I'm not good at 3d design