Christus Statue
Remixed by
Copyright Claim
Christus Statue
Remixed by
Boost
16
26
5
Print Profile(1)
Tree Slim Support - 0.08mm layer, 2 walls, 15% infill
Designer
6.9 h
1 plate
Open in Bambu Studio
Boost
16
26
5
2
69
38
Released
Description
Wanted to try out a Christus statue. This is the second STL I've tried and it's very well done by nykyly on Thingiverse.
The only casualty during support removal was the left pinky. To beware of that weak point.
If you figure out better print settings, please share!
Comment & Rating (5)
All
Print Profile
Tree Slim Support - 0.08mm layer, 2 walls, 15% infill
the supports are very challenging to remove, those supports at back feet are almost impossible to get. otherwise good design overall.
(Edited)
The designer has replied
0
Reply
I totally agree with you there. There's some details that are just a little too small to come out easily at times.
0
Reply
Print Profile
Tree Slim Support - 0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Tree Slim Support - 0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Tree Slim Support - 0.08mm layer, 2 walls, 15% infill
0
Reply
No more
Related Models
© 2024 MakerWorld