Hueforge - Disney - Jack Skellington

Hueforge - Disney - Jack Skellington

Boost
35
65
3

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.08mm layer, 2 walls, 100% infill
0.08mm layer, 2 walls, 100% infill
Designer
3.6 h
1 plate
5.0(2)

Boost
35
65
3
1
21
22
Released

Description

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 5.2
PLA Sovol PLA White Transmission Distance: 8.8

Swap Instructions:
Start with Black
At layer #12 (1.04mm) swap to Orange
At layer #16 (1.36mm) swap to Yellow
At layer #20 (1.68mm) swap to White for the rest.
 

**IMPORTANT INFORMATION**

  • You cannot adjust the z scaling on any hueforge. This will mess with the coloring done and your hueforge will not come out as intended. You can however change the x and y to scale the picture. I recommend only changing by the same percentage.
  • To get an accurate print as shown in the photos you MUST use the same filaments listed below. You can change brands (as long as they are similar) but keep the filament colors the same. If you use any other color, you will not get the same results as me.
  • What you see in the slicer will not be how the final results will look! Hueforge takes advantage of color bleed to make the blended colors!

 

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Print Profile
0.08mm layer, 2 walls, 100% infill
The designer has replied
0
Reply
Thank you for the support!
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
No more