Hållbar (IKEA) floating wall bracket

Hållbar (IKEA) floating wall bracket

Boost
8
21
2

Print Profile(6)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 6 walls, 25% infill
0.2mm layer, 6 walls, 25% infill
Designer
43 min
1 plate
4.5(2)

0.2mm layer, 6 walls, 25% infill
0.2mm layer, 6 walls, 25% infill
Designer
1 h
1 plate

0.2mm layer, 6 walls, 25% infill
0.2mm layer, 6 walls, 25% infill
Designer
3.6 h
1 plate

0.2mm layer, 6 walls, 25% infill
0.2mm layer, 6 walls, 25% infill
Designer
5.4 h
1 plate
Click to see more

Boost
8
21
2
0
6
5
Released

Description

Floating wall brackets for the IKEA Hallbar (Hållbar) 10 liters and 3 liters bins.

 

The angles are carefully designed, so the bottom of the 10 liter bin rest againt the wall.

The bracket position (where the bins hooks on) is also placed, so the lid on the bins can be opend, and not fall shut.

 

 

This also goes for the 3 liter bracket, but here there is an addition in the design.

So when 10 liter and 3 liter are placed beside each other, they will hang with the same angle, to give a more pleasing look.

 

I dont recommend using the 10 liter bracket for the 3 liter bin, as it will hang with a steaper unsupported angle, and therefore stress the hooks.

 

 

There is also include a trashbag ring for the 3 liter bin, as IKEA dont make/sell these.

This is made, to look like the original for the 10 liter bucket.

 

 

Strenght print settings for brackets:

  • Infill : 25%
  • Walls: 6
  • Top/bottom shell layers: 3-4
  • Support needed for holes

 

Basic print settings for ring:

  • Infill : 15%
  • Walls: 2
  • Top/bottom shell layers: 3
  • No support needed

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 6 walls, 25% infill
prints fine, but imho the supports are kind og unnecessary!
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more