The Shawshank Redemption movie poster magnet by crabstiks

crabstiks

Household>Decor

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.08mm layer, 2 walls, 15% infill

Designer

3.7 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

Released

Description

The Shawshank Redemption movie poster fridge magnet.

Measuring 65mm wide by 95mm high by 5mm deep

4 colour AMS print, using black, lemon yellow, white and orange.

This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.

NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.

Comment & Rating (8)

@rggalvin

Great movie/poster. For some reason, though, it had problems with the M and the N in REDEMPTION.

The designer has replied

@rggalvin

On re-review, it looks like changing the Wall Generator to 'Classic' messes up those 2 letters. But, if I leave it at 'Arachne', the slicer freezes at 15% (and, I'm running the latest Bambu Slicer version). I've had to change the wall method, all day long on 3 of 4 prints. Not sure what has changed...

@crabstiks

Replying to @rggalvin :

It does need to be on Arachne with the numbers I set to get the thin lines in the letters but doing that does use quite a lot of pc resources. Maybe try slice and print it directly from the Bambu app?

@rggalvin

Replying to @crabstiks :

I am doing it direct from the Bambu slicer (and, I've got a beefy PC (64GB mem, i9, etc)). Either way, it's working again, today, so it must have just had gremlins (like your model, which I'd print if I had brown filament)! :)

(Edited)