Search models, users, collections, and posts
Print Profile(2)
0.2mm layer, 3 walls, 10% infill
Designer
4.1 h
2 plates
PLA, 0.2mm layer, 4 walls, 15% infill
Designer
3.1 h
2 plates
Open in Bambu Studio
Boost
11
73
7
3
40
19
Released
Description
The spring is already here, and it's time to put new plants in our life. I hope that this stackable desing helps you to put a bit of green on it.
- PETG recommended.
- Tested with 3 floors, but although it can handle more then you will need to check how you are going to irrigate the lower floors.
- The base is not mandatory, specially in the outside.
- Two plates. The first is for the pot floor, the second is the base. Print as many floors as you want
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)