Ironing Test for big surfaces by tholey

tholey

3D Printer>Test Models

Print Profile(2)

All

A1, PLA, 20mm/s, 0.2mm layer, 2 walls, 10% infill

Designer

1.7 h

1 plate

5.0(2)

A1, PLA , 15mm/s,0.2mm layer, 2 walls, 10% infill

Designer

2 h

1 plate

5.0(2)

Boost

Released

Description

I asked myself wether it's possible to use ironing for big surfaces. So i decided to test some settings and this test arised. I added a great to see its behaviour at some corners. This test is made for 15 and 20mm/s. 25mm/s is on its way. I hope it will help u.

Please notice: This values are not useful for small surfaces like letters. Therefore use my standard ironing test:

https://makerworld.com/en/models/175615#profileId-193062

Comment & Rating (7)

@AeonJoey

Print Profile

A1, PLA, 20mm/s, 0.2mm layer, 2 walls, 10% infill

thank you so much! I was having problems printing specifically larger areas, and this helped immensely!

@marcelnic

Boosted

Print Profile

A1, PLA, 20mm/s, 0.2mm layer, 2 walls, 10% infill

Habe vorher nie schönere Oberflächen hinbekommen

@zitro101

Can i use this for petg?

The designer has replied

@tho_le

Sorry only for Pla, but you can download my stl and try it yourself

@AeonJoey

Thank you for this, I've done several of these tests but have problems when printing large flat areas with ironing and under-extrusion. The fact that you have these at 15, AND 20 mm/s alone tells me the defaults are way too high; at 30mms, and 10% flow, with your test starting at 30%. I've had some good luck with 30mms + 25% for large flat areas with Polymaker Polyterra (around 3" square and 3x6" areas) but with Bambu Black Matte i'm having the worst underextrusion using those settings. I'll give this a shot! Thank you!