WD-40 Push-On Straw.
12cm long.
Print:
Print in two parts and then glue together. Ensure rounded part of elbow section is pushed onto WD-40 can, and non-rounded is fit into straw section.
Print with no supports on straw section and minimal support on elbow. Only support on build plate for elbow, or else supports will be impossible to remove from inside the piece.
Install:
Remove cap from can.
Fit replacement straw onto top of can, ensuring rounded part of elbow if pushed onto can.
Enjoy!
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.