I couldn't find a phone stand that integrates the JBL GO 2 bluetooth speaker to my liking so I decide to try and make one myself.

I wanted something with a small footprint that is decently stable and easy enough to (re)print and after a few iterations this is what I came up with. Controls and charging port are accessible and the mesh lid doesn't impede much of the sound.

Hardware needed:

• 4 M3 Heat Set/threaded Inserts
• 4 m3 6-8mm BHCS screws

The two parts print separately and require supports. The fit is pretty tight, just some slight horizontal play.

Print in PETG if you plan to use this outside, else PLA should be fine.