Just a little friendly crocodile 🐊 keychain, based on Coco.

Print suggestions & troubleshooting

Brim is enabled but if you have excellent adhesion to the print bed, you can disable it. If you decide to keep it enabled, you will have to remove the brim after printing: I use this tool which makes the task easier and precise. If you notice the object becoming discolored where the brim was present, a brief burst from a hair dryer or heat gun can help re-melt the filament just enough to restore its original color. Be careful not to overheat, as this can cause the strands to melt together, resulting in a messy outcome.

Scaling

I suggest you don't scale the object making it smaller, it could create joints issues.

Commercial license

Do you want to sell prints of this model? You can purchase commercial licensing for this model by joining the Commercial License in my Patreon.