Christmas / Birthday Gift Card Box with Ribbon
Copyright Claim
Christmas / Birthday Gift Card Box with Ribbon
Boost
61
140
27
Print Profile(3)
2 Plates, Standard Layer Height, 10% Infill
Designer
1.3 h
2 plates
0.2mm layer, 2 walls, 10% infill
1.2 h
2 plates
A1 mini, 0.2mm layer, 2 walls, 10% infill
1.6 h
2 plates
Boost
61
140
27
0
320
326
Released
Description
Small Box to put a Gift Card in, already scaled to make a neat fit. Print it like the STL is for best results.
Remixed from an older design by feddasaur
Comment & Rating (27)
All
Print Profile
2 Plates, Standard Layer Height, 10% Infill
great print
0
Reply
Print Profile
2 Plates, Standard Layer Height, 10% Infill
Looks great, prints easily.
The box fits a gift card well and closes nicely. The ribbon and bow are perfectly sized and attach well to the box and each other with superglue.
The gift recipient was quite impressed! I printed the box on an H1H phantom build plate for a certain sparkly sheen. But the ribbon and bow in yellow silk PLA were especially effective.
Thank you for the model!
0
Reply
Print Profile
2 Plates, Standard Layer Height, 10% Infill
Printed this for teacher appetition and she really enjoyed getting it was a fun print. Only thing i would say could have been my print but the lid didn't fit tight so would fall off pretty easy in my case wasn't the biggest of deals but could have been a problem for some
0
Reply
Print Profile
2 Plates, Standard Layer Height, 10% Infill
Very, very, nice to use as gift box. Should be nice when lid is more close to the edges of the box so the fitting is more precise.
0
Reply
Print Profile
2 Plates, Standard Layer Height, 10% Infill
added names too
0
Reply
Print Profile
2 Plates, Standard Layer Height, 10% Infill
top surface was a little rough but otherwise functional foldable print in place gift card holder - even with non BL Filament.
0
Reply
Print Profile
A1 mini, 0.2mm layer, 2 walls, 10% infill
1
Reply
Print Profile
A1 mini, 0.2mm layer, 2 walls, 10% infill
1
Reply
Print Profile
2 Plates, Standard Layer Height, 10% Infill
0
Reply
Print Profile
2 Plates, Standard Layer Height, 10% Infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld