Stream Deck MK2 - Corsair K70 Mk.2 Mount
Stream Deck MK2 - Corsair K70 Mk.2 Mount
Boost
1
0
3
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
59 min
1 plate
Boost
1
0
3
0
5
2
Released
Description
I made this mount to fit on the left side of the K70, right over the buttons (as I don't use them).
It gives you quick access to the deck as it sits close to the F keys.
You will need to print 2 of these.
Slide the each one onto the deck, then slide the complete assembly onto the keyboard. You'll have to close the keyboard foot and then open it again once it clears.
Comment & Rating (3)
All
Just to let you know it turns out I have the K95 keyboard which is very similar but has a larger lip at the rear. I have modified yours and published on here also, I have credited and linked your model as the original. Thanks again. you saved me a lot of time designing it from scratch
1
Reply
Just downloaded this as lost my original stand and have the same keyboard. going to print in PLA as a test and then PLA CF I think to make it pretty
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld