UPDATE: Version 2 Available here: https://makerworld.com/en/models/440444#profileId-346135 which should be better in all regards
-----------------------------------------
------------------------------------------
Note: This is version 1.3 of my popular “Door holder handle latch”. It's almost identical but it has a longer/deeper insert for the hinge between the handle and the latch for those that found they came apart too easily. (The hinge is incompatible with the original version which is why this is posted as a new model.)
As recommended on the Bambu Wiki You should leave the P1S and X1C door open to prevent heat creep causing clogs when printing PLA etc - but I did not like the way the door swings around during prints as this cannot be good for print quality.
There are some door stops out there, but as they are not always attached I kept losing them, so I designed one that attaches to the door handle without needing any tools, screws or assembly. And as a bonus, it also makes it easier to open the door compared to the standard small handle.
It works well for me - let me know if it works for you :)
Also - check out my matching top glass holder: https://makerworld.com/en/models/413801#profileId-315832
If anyone has an issue with printing it in place, I have uploaded separate models of the handle and latch and also a looser version of the latch which helped some people for whom the fit of the original is too tight. Please do not force it on if it is too tight, print out the looser version, it will only take you 20 minutes :). Or some have printed at 101 or 102% for a comfortable fit.