Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
49 min
1 plate
Open in Bambu Studio
Boost
21
49
9
0
58
24
Released
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
print failed every time
The designer has replied
0
Reply
what is the issue?
0
Reply
is it sticking out off the bed?
0
Reply
if yes try to give your bed a good soap clean and make sure that you have chosen good 3d printer.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
could not get these to print
The designer has replied
0
Reply
what was the problem?
0
Reply
Replying to @user_2261555884
If you use the default profile, one of the ear stalks and the glasses themselves aren't flat against the build plate. I printed first from my phone and didn't see that, and got a spaghetti monster. Looking on my laptop now and I see this issue and will try a re-print.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed out perfectly!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld