porta chiavi e monete
Copyright Claim
porta chiavi e monete
Boost
55
48
19
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
29 min
1 plate
Strength Profile, 0.2mm layer, 3 walls, 25% gyroid infill
34 min
1 plate
0.2mm layer, 2 walls, 15% infill
34 min
1 plate
Open in Bambu Studio
Boost
55
48
19
3
58
51
Released
Description
Portachiavi e porta monete
si assembla con colla
e si chiude a scatto
Comment & Rating (19)
All
Print Profile
Strength Profile, 0.2mm layer, 3 walls, 25% gyroid infill
work
The designer has replied
1
Reply
Thank you for your rating!
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good
0
Reply
Boosted
Thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed tolerances are a bit too lose
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
super usefull
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
NO se me imprimió bien, no cierra y se abre solo, puede ser que tenga que ver que use un filamento algo antiguo, pero la idea me gusta y volveré a imprimirlo con otro filamento a ver si queda mejor.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very cool design - the print was perfect! Thank you
0
Reply
Perfekt! Thx
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Gut zu drucken, leider halten die Hälften nicht zusammen. Der Verschluss müsste nochmal überdacht werden.
(Edited)0
Reply
Print Profile
Strength Profile, 0.2mm layer, 3 walls, 25% gyroid infill
The designer has replied
0
Reply
Thank you for your rating!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld