Legend of Zelda: Tears of the Kingdom
Boost
81
140
16
Print Profile(1)
Zelda Tears of the Kingdom - 0.2mm layer, 2 walls, 15% infill
Designer
3.2 h
1 plate
Open in Bambu Studio
Boost
81
140
16
4
148
45
Released
Description
Legend of Zelda: Tears of the Kingdom art based on the Complete Official Guide cover.
Comment & Rating (16)
All
Print Profile
Zelda Tears of the Kingdom - 0.2mm layer, 2 walls, 15% infill
came out amazing !
The designer has replied
1
Reply
Very nice ;) Thanks for sharing!
0
Reply
Boosted
Printed on my A1 and turned out amazing!
The designer has replied
0
Reply
Very nice! Thank you for sharing!
0
Reply
Print Profile
Zelda Tears of the Kingdom - 0.2mm layer, 2 walls, 15% infill
would rate it 5 but says I didn't have a successful print but i did WTF
The designer has replied
0
Reply
Odd. I have only seen messages about a unsuccessful print after canceling because of warping or a part became detached. I wonder if it was just a Bambu Studio goof?
(Edited)1
Reply
Boosted
Cool one. Single color, then painted. Printed nicely.
0
Reply
Print Profile
Zelda Tears of the Kingdom - 0.2mm layer, 2 walls, 15% infill
awesome print!
0
Reply
Print Profile
Zelda Tears of the Kingdom - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Zelda Tears of the Kingdom - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Zelda Tears of the Kingdom - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Zelda Tears of the Kingdom - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Zelda Tears of the Kingdom - 0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld