This is a remix of Philipp's Filament storage Box with seal. I loved the original design but had a problem with the range of motion on the hinges, if they were pushed too far they would break. I also wanted a way of identifying what color and type of filament was in the container. Hence Ver 2. No special requirements or supports, just use the 3MF file and you should be good to go.

I just cut the filament info from the cardboard box it came in and slipped it into the label holder. The spring to hold the label in is printed as part of the holder.

I glued the holder to the container using Star Bond superglue.

Screws

Hinges used M3x30 cap screws

Latches used M3x20 cap screws

Don"t overtighten