Mineral POORGE/ POOP by Ryno77

Ryno77

Art>Sculptures

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.5 h

1 plate

4.0(2)

0.2mm layer, 1 walls, 0% infill

Designer

2.1 h

1 plate

3.5(2)

0.2mm layer, 2 walls, 0% infill

Designer

2.5 h

1 plate

Open in Bambu Studio

Boost

Released

Description

Finally you will be able to print an empty mineral where you can put that unusual poop and make it a furnishing object for your home or office.
There are two objects ready to print: the mineral and the base where you will join together

with a little glue after placing the colored poop.

REMEMBER that you can print single-walled for transparency or use the available double-walled profile and make the poop less transparent .

Good print …

Comment & Rating (8)

@wolfboywestphal

printed this twice, once time it came loose from the plate half way through, I noticed the print head doesn't clear the print and drags on it making a click as it drags across the print, added a raft n brim to hold it to the plate, it printed but on several of the crystals it did not print on the upper facets, I think its part of the 1 wall print setting, on the top surfaces it probably should be 2, oh well I thought I'd give it run, it's a cool idea just needs some tuning and it will be great, thanks for making it, I hope this helps

@user_1493637852

Tried printing this several times with no luck. Appears to need supports or a printer setting that I am not familiar with.

The designer has replied

@Ryno77

hi, I'm sorry that you can't print it, but the project is created without the need for supports, the advice I can give you is to check the first layer and print in normal mode as per the project and as you can see from my photo the mineral came out without any problems, finally check that your filament is not too wet. hi give me some news