Starship LED glow in the dark lamp. Is a replica from the reservoir and tube disposition of SN8 and mix with one of the renders of the future starship. Reason to not update to the new reservoir disposition is that looks cooler this way

Dimensions:
Height: 52cm - divided in 3 sections so it can be printed in almost any printer
Diameter: 9 cm not including the extra length of the canards.

LEDs can be installed on the inner tube and a back access panel has been added to allow operation of the LED controller.

There are spot faces for 5mm magnets but i don't use them since the fit is very good and does not require it

Please in case you want to use it for commercial purposes contact me.
Notes:

Printed with a 0.4mm nozzle and 0.2mm layer height using PLA. Some of the files require supports.

It's designed to use glow in the dark filament which require thick walls and 100% infill. Please be aware that the glow in the dark PLA might damage your nozzle in the long term.

For the canards only the LH models have been uploaded, just do symmetry to them. For the covers of the canards print them in a 60-70 degrees to minimize the support required but allowing good detail print of the shields. Shields have to be glued to the canards after installation.

File name states if supports are required, the color, the material and the infill for the glow in the dark. For the cannards is also recommended to use 100% infill.