Light weight poop chute (30g)
Copyright Claim
Light weight poop chute (30g)
Boost
22
45
19
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
3.8 h
2 plates
0.2mm layer, 2 walls, 15% infill
Designer
6.2 h
2 plates
Boost
22
45
19
1
86
48
Released
Description
Light weight poop chute only 30g PLA/PETG if you do not print either of the buckets.
No supports needed.
You can also see my other printable add-ons for the Bambulab printers:
https://makerworld.com/en/models/213926#profileId-233439 (AMS button adapter with PTFE tube)
https://makerworld.com/en/models/402613#profileId-304285 (Dual purpose bed scraper)
https://makerworld.com/en/models/394761#profileId-295931 (If you need to connect two bowden/PTFE tubes)
https://makerworld.com/en/models/375898#profileId-275865 (Drybox IKEA samla 22l)
https://makerworld.com/en/models/404520#profileId-306293 (Purge strip bin for Bambu P1S)
Comment & Rating (19)
All
I printed it with basic PLA and everything worked out well
The designer has replied
1
Reply
Looking great :)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Materials: White PLA Basic
I would recoommend painting a small support column at 1/3 and 2/3rds of the way up the chute slide to stabilize the plastic during printing.
My printhead made the plastic flex when it reached halfway up on the diagonal slide surface, you can see the stepping that caused- but the slide is still solid and I can use it just fine.
I love the inset decorations and used some acrylic paint to highlight them! The slide works perfectly.
(Edited)
1
Reply
Thank you, I am going to try and print this one for my new P1s since it uses the chute screw and has a detatchable basket. Perfect! I am curious if there is any special reason for the two rectangular holes on the chute itself?
The designer has replied
1
Reply
That is when you have to mount the chute the allen key and screw can go into the hole and then screw them in.
1
Reply
Nice! I hadn’t thought about that. great design. ☕️
0
Reply
Love this design, however the poop settles at the end of the chute where the flat landing is, I have to manually push it into the bin. I would avoid the turn and continue the chute straight to have a good pitch to fall into the bin naturally. Fix that and this chute will be the best chute on here!
The designer has replied
1
Reply
was also thinking of that so no turn and widen at the end? and then the bucket just have a nudge in the side instead?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
☺️
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Just turns out perfectly!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Fast and works great!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld