Shoe Horn
Copyright Claim
Shoe Horn
Boost
43
71
26
Print Profile(1)
0.2mm layer, 4 walls, 50% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
43
71
26
9
146
167
Released
Description
A simple fully printed shoehorn used to help get shoes on foot.
Prints without support lying horizontally.
Have fun with it and leave a like or subscribe if you like it!
If there are any suggestions for improvement, feel free to write a comment.
Comment & Rating (26)
All
Print Profile
0.2mm layer, 4 walls, 50% infill
I can put my shoes on without braking it so I said it does work. quick print and it feels steady.
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
👍
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
it works well use it all the time
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
It's tough enough to not brake printed in PLA, but it hurts a little because of the curved form. It pokes my foot with the end of the horn a little while using. Maybe a Design a little more linear should fix the 'problem'.
0
Reply
also you probably should print this in TPU considering TPU’s elasticity would make it hard to break and also wouldn’t hurt quite as much as PLA
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
It's good but it has to been in another size: you have to put divverent sizes.
But very good!!
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
nice strong print
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
I've been needing this for a while, great design, works perfectly.
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld