Refrigerator wine bottle rest/stand
Copyright Claim
Refrigerator wine bottle rest/stand
Boost
10
32
5
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
3 h
1 plate
Boost
10
32
5
0
39
24
Released
Description
This model mimics the stands that came without Fisher and Paykel fridge. Unfortunately, it only came with two stands and we often need more than that. 😀🍷
The design clips over a metal strip at the back of the fridge shelf to hold it in place. If your fridge does not have this, adding some non-slip rubber feet to the bottom would be a good idea.
Unfortunately, this model needs support materials to print.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 3 walls, 25% infill
took a few tries to get this printed, some if it was probably on my end. after I got it setup and printed with only one filament instead of using the support filament but it still did a prime block for no reason
The designer has replied
0
Reply
Wow, the print looks good. I'm delighted that someone has been able to get use from the design.
I'm not too sure why it still used a prime block. Apologies.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
Printed great. Just some odd results with the supports, my filament has no additives to make it easier to print so it's not something most people will encounter. But I think a few simple changes to print it no supports flat on the bed instead of on its side is probably more successful generally.
For anyone who wants to try that you can just rotate it in bambu studio and lower the print bellow the bed to y=-0.12 and it'll skip the first 56 layers, print flat no supports.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
This is exactly what we needed! Works perfectly.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld