Funko POP Light Box
Copyright Claim
Funko POP Light Box
Boost
71
93
27
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.3 h
2 plates
Boost
71
93
27
0
118
139
Released
Description
Friend asked for a funko light box. Here it is. Hope you enjoy!
Comment & Rating (27)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Logo went through purge line.
The designer has replied
0
Reply
prior to printing in the slicer it should show that. so should always remove before actual printing starts
(Edited)1
Reply
Replying to @BeardedDadDesig
That's why I still gave you 5 stars...because it was my fault lol
0
Reply
Replying to @BeardedDadDesig
How do you remove it?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great box
0
Reply
any chance you could add an offset to the inside of the O??
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Hello, do you have the raw files? I would like to add an opening on the back to hang it on the wall.
The designer has replied
0
Reply
you can add the opening in the slicer by adding a negative object
0
Reply
Replying to @BeardedDadDesig
Ah thanks. Didn't knew that bambu slicer could do that!
1
Reply
Replying to @LogoKing
No problem. I hope that helps. easiest way I know.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
too close to the edge cause’s spaghetti every time .
The designer has replied
0
Reply
sounds like a build plate issue. not once have I had or heard of spaghetti from a Lightbox. try doing first layer bed temp to 75c
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Just need screw wall mounts to be perfect
0
Reply
awesome print!! looks great next to my Funko’s
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld