Robocop movie poster fridge magnet
Boost
28
19
12
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
3.1 h
1 plate
Open in Bambu Studio
Boost
28
19
12
1
21
21
Released
Description
Robocop movie poster fridge magnet.
Measuring 65mm wide by 95mm high by 5mm deep
4 colour AMS print, using black, silver silk, white and beige.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (12)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
esta muy bien
The designer has replied
1
Reply
Thank you!
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Thank you for a fantastic print, perfect to display next to dioramas.
The designer has replied
1
Reply
😮Nice job! And thank you for the rating, I appreciate it
(Edited)1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Looks great!
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Are you taking requests? I would love to have "Escape from New York" and "Big Trouble in Little China".
The designer has replied
1
Reply
I am open to suggestions and I'll take a look at those two... Though not every movie is possible to get looking good in a limited number of colours and at a small scale
0
Reply
Boosted
i’m going to run out of room if you keep making these from the best 80s movies
The designer has replied
1
Reply
Sorry not sorry 😂my own fridge is getting pretty full too
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld