Tarmogoyf - Magic the Gathering - 7 Colours

I might revist this again when I install a 0.2 Nozzle so I can do 0.04mm layer heights, but for now, this was printed with a 0.4 and 0.08mm layers.

In my print profile I have assigned the model to have a variable layer print height, which means that the first 4 layers of the model will print with a 0.16 layer height, and switch to a 0.08 layer height for the details. If you use my uploaded print profile this will save you time on your print as the first 0.64mm is just to provide stability to the print for display. This means that the layer heights listed below in my printing instructions will not match my print profile (they will be off by 3) but the mm heights will still match! Do not change the print profile to match or it will not look the same!

If you resize the model make sure you do NOT scale the Z axis or the print colours will not be in the same position

-------------

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Generic Black Transmission Distance: 0.2
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Matte Dark Brown Transmission Distance: 2.1
PLA Bambu Matte Dark Green Transmission Distance: 4
PLA BambuLab Basic BambuLab Green Transmission Distance: 2
PLA BambuLab Matte Latte Brown Transmission Distance: 2
PLA BambuLab Matte Ivory White Transmission Distance: 4

Swap Instructions:
Start with Black
At layer #13 (1.12mm) swap to Blue Gray
At layer #15 (1.28mm) swap to Dark Brown
At layer #16 (1.36mm) swap to Matte Dark Green
At layer #18 (1.52mm) swap to BambuLab Green
At layer #20 (1.68mm) swap to Latte Brown
At layer #22 (1.84mm) swap to Ivory White for the rest.