This is a modified Fantasy Football Trophy from user egut125. The top portion is relatively the same other than dow rods that I have added.

The base was modified to hold up to 23 name plates.

I magnetized the name plates as oppose to glue because it allows for the most recent winner to be at the top and slide everyone else down. Magnets used are 5mmx2mm and will fit snug into the base itself. The same size magnets go into the name plates. You will have to create a pause when printing the name plates in order to place the magnets inside. It is very important to make sure your polarity of magnets match up to the corresponding other magnet or they will repel and not attract.

The plates can be taken out and placed anywhere else on the trophy base, using a small screwdriver. I printed some blanks for future years and current list of winners our league has.

The settings in the upload are the ones I used except did not use supports for the spaces in the base, however did have some minor irregularity and wish I would have, so I did turn those back on. (feel free to turn off if you do not like supports, although you may have some shift or stringing)

I used expoxy to connect the top portion to the base and let it set for 24hrs.

Shout out to egut125 for the a great design.