This is my design of a Highland Cow using the software HUEFORGE. It's perfect for a gift or to decorate your room. This file is suitable for all printers (not only Bambu). If you don´t own a Bambu, just take care of the layer height to make the filament change.

Please print at 0.08 layer height. color note Here:

Swap Instructions (Just in case you want to make the filament changes manual):

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Silver Transmission Distance: 0.5
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions: If you only want to run four colors combine Grey & Silver as ONE COLOR so layer #12 Gray, layer#19 White
Start with Black
At layer #8 (0.72mm) swap to Blue Gray
At layer #12 (1.04mm) swap to Gray
At layer #17 (1.44mm) swap to Silver
At layer #19 (1.6mm) swap to Jade White for the rest.