Wall of Magikarp Pokemon ( Hueforge )
Copyright Claim
Wall of Magikarp Pokemon ( Hueforge )
Boost
27
40
1
Print Profile(2)
0.08mm layer, 3 walls, 100% infill
Designer
2.3 h
1 plate
A1 mini profile
Designer
2 h
1 plate
Open in Bambu Studio
Boost
27
40
1
0
16
5
Released
Description
⚠️⚠️⚠️The filament that I used is included inside the 3mf file!⚠️⚠️⚠️
Stand used in this photos : https://makerworld.com/en/models/389470
I hope everyone enjoys this and gives it ⭐⭐⭐⭐⭐!
Credits: https://www.pinterest.it/pin/8796161766821579/
My other design:
Comment & Rating (1)
All
Print Profile
0.08mm layer, 3 walls, 100% infill
not a bad print, but I wish you could print multiple plates and they would fit together. the yellow layer isn’t very good, as you can see some of the magikarp lips are completely yellow and others are not.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld