Goku Super Saiyan Pixel Art

Dimensions: 22.5 x 37 x 1 cm 8.9 x 14.6 x 0.4 inch (length, height, depth)

Print Settings:

Use standard setting .20mm Layers + Only one wall on first layer + AUX OFF

No Supports

Total pieces 984, construction time approximately 80 minutes

I used:

401 Pins BLACK Sunlu PLA+

20 Pins DARK PINK

1 Pin GREY Sunlu PLA+ Silver

1 Pin GREEN Sunlu PLA+ Light Green

3 Pins WHITE Sunlu PLA+

9 Pins RED Sunlu PLA+

34 Pins CYAN Bambu Lab PLA Basic

38 Pins BLUE Sunlu PLA+

103 Pins PINK Sunlu PLA+

90 Pins ORANGE Sunlu PLA+

87 Pins DARK ORANGE

81 Pins YELLOW ORANGE

116 Pins YELLOW Bambu Lab PLA Basic

For DARK PINK, DARK ORANGE and YELLOW ORANGE I used 2 colors to get them.

DARK PINK 0.6 mm of Sunlu PLA+ Skin and Sunlu PLA+ Black for the rest

DARK ORANGE 0.8 mm of Sunlu PLA+ Orange and Sunlu PLA+ Black for the rest

YELLOW ORANGE 0.2 mm of Bambu Lab PLA Basic Yellow and Sunlu PLA+ Orange for the rest

If you already have the shaded colors, print those directly, otherwise I have prepared a file where you can test the shades directly with your colors. So as to have an excellent result, as the shade changes according to brand, model, color, material, etc...

I have also included an extractor to make it easier to remove the pins in case of a mistake and two extensions to attach to the back for a more stable model.

Fit the pins on the opposite side to the printing surface to obtain a planar result. The pins must be lightly pointed by hand then a hammer is needed to drive them all the way in.

Here you can understand where the colors are positioned. Have a good construction