Tool drawer for nozzles & more
Copyright Claim
Tool drawer for nozzles & more
Boost
48
94
8
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
10.9 h
3 plates
Open in Bambu Studio
Boost
48
94
8
6
88
26
Released
Description
A simple tool drawer for nozzles and more.
Some people had problems with bad bed adhesion and warping. I use the 3DLAC glue to get perfect results.
If you dont use any adhesion helper like this I would recommend using a brim to avoid warping.
Comment & Rating (8)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Great print. Came out nicely in an orange/silver PLA combination. The only issue was a slight warping of the bottom of the drawers, but I suppose it was mainly due to poorly degreased print sheet. The corners lifted slightly, but it does not affect neither looks nor function. Overall it is a really nice storage for my tools and spares. Thanks for the model.
The designer has replied
0
Reply
I like the grey-orange combination a lot! I had no issues because I always use the "3DLAC" Spray for perfect bed adhesion. If I would have known there will be problems with warping, I should have said in the description to use a brim or adhesion spray. Thanks for your comment.
(Edited)0
Reply
Boosted
Amazing design, came out great. I used my own profile, so it prints faster with a 0.6mm nozzle, but the drawer is awesome.
Thank you.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Worka very well and prints great
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld