Hello everyone this is my first design and build. I have a fanatec shifter and ebrake mounted vertically for my rig. I have a hard time with scraping my knuckles and hand on the e brake as I shift into 7th gear. This spacer is 10mm thick and I used 5mmx20 screws to mount the spacer and the e brake.
I used PETG as my plastic
I did
6 wall loops
7 top and bottom layers
15% sparse infill Gyroid
I slowed the outer wall down to 100mm/s
Also slowed inner wall to 200mm/s
I know there are probably better settings, but i am happy with the turn out.
I used a caliper to roughly measure the part out. It overlaps in the back side a little bit, but not too much.
I hope this helps someone out. Good luck racing